2K WHITE SEALER GALLON KIT WITH QUART ACTIVATOR (XL-37001-37104)

Description

2K WHITE SEALER GALLON KIT WITH QUART ACTIVATOR (XL-37001-37104)
Excel 2K Sealer is a two-component acrylic urethane primer sealer formulated to be applied as a low build non-sanding sealer. #37001 offer excellent filling properties with minimal coats, fast dry, excellent adhesion, easy sanding and superior color holdout. #37001 does not shrink and can be tinted with basecoat tints. Surface Preparation, Bare Substrates Solvent wash surface with a good grade wax and grease remover such as Excel 91001 and wipe dry with a clean cloth. Apply three single wet coats of Excel 32001 Series Epoxy Primer according to instructions on data sheet. Surface Preparation, Prepainted Substrates Wash surfaces with a mild detergent and hot water. Rinse with clean water and wipe dry with a clean cloth. Solvent clean with Excel 91001. Wipe dry with a clean cloth. Sand original paint and repair damaged areas with a good quality non-staining body filler. For spot repairs, scuff sand area where primer will be applied. For overall refinishing, scuff sand the entire car with 320 grit sandpaper or fine scuff pad. Mixing Directions, Sealer 4 Parts #37001 2K Sealer 1 Part #37104, #37116 Activator Series Application, High Build and Normal Build Adjust air pressure at the gun to 30-45 psi for siphon feed guns. Use less pressure to minimize over spray on small jobs. Apply 2-3 medium wet coats at a gun distance of 8-12 inches as needed to fill voids and block sand with 180 to 280 grit treated sandpaper. Allow 10 to 20 minutes flash time between coats. Recoat times will vary with temperature, air movement and film thickness. Insufficient flash time will promote slow hardness development of the topcoat system. Finish sand repaired area with 320 grit sandpaper using a DA Sander or hand sander. Application, Sealer Adjust air pressure at the gun to 30-45 psi for siphon feed gun. Use less pressure to minimize over spray on small jobs. Apply 1 or 2 wet coats at a gun distance of 8-12 inches. Allow 30 minutes flash time before top coating. Recoat time will vary with temperature, air movements and film thickness. Insufficient flash time will promote slow hardness development of the topcoat system.
FREE SHIPPING TO THE LOWER 48 STATES
Alaska & Hawaii extra shipping charge
PROVISION Auto Body Supply
Providing Quality to Professionals. Buy with confidence.