2018 - 2021 Ram Pickup Cummins SGW Security Gateway PassThru Harness

Description

Tune MY Trucks's 2018+ CME Bypass Cable (also known as the Security Gateway Module Bypass Cable) can be used in multiple ways and using multiple platforms. You will need this cable - On the 2018's to flash a CSP5 tune for EFILive
®
, for EZ LYNK for changing tire size or adding a remote start. for MM3 if your security module fails. Or, just in general to bypass the security gateway module. This cable is meant to be installed and left in the vehicle. It is intended to be uninstalled and re-used on other vehicles. Once installed, the OBD-II will still function normally. Also, you must leave it installed in order to use a CSP5 switch/tune for EFILive
®
.
*****This auction is for the 100% plug - n - play bypass! please visit our other listing for the other wire in style!*****
2018 / 2019 / 2020 Cummins Bypass Cable Installation
For Our 2 - Wires Design only-
1.   Remove the cable from package. Purple Pin 6 Grey Pin 14
2.   Carefully, remove the OBDII connector from the dash by depressing the tabs on the sides.
3.   Remove the two grey pin retainers from the back of the connector.
4.
One at a time, remove & replace the yellow and brown wires from locations 6 & 14. For a 2018 truck,  For the 2019 and 2020 follow the same steps.
NOTE: If you install the cable and can’t connect to the truck, try swapping the wires.
Note:
A 1.5mm wide flat terminal release tool or a pointed sewing needle works for removing pins.
OBDII Connector
5.   Reinstall the two grey pin retainers.
6.   Locate the green “Star” connector above the parking brake
. For 2018 plug the harness into any empty space, for 2019 and 2020 plug the harness into the fifth position from the left at the bottom.
2018 Star Connector
2019/2020 Star connector
7.   Cover & insulate the pins you removed from the OBDII connector.
8.   Reinstall the OBDII connector into the factory location.
The bypass cable will also likely be needed in the following scenarios:
Changing the tire size with EZ LYNK
Adding an aftermarket remote start
Using a Snap-on or other OBDII scanner
Adding AMP Steps
Alpha OBD
Elm Support
Efi Live Support
If you want EFI-LIVE on your 2018 + Ram Pickup Or any other Tuning platform and need to Bypass The Security Gateway you need this harness! Developed by enthusiast to make a easy and clean durable installation. If you have a Cummins diesel or hemi this is for you! Don't fish around the internet buy the best!
1 year warranty
Molded Design
3 easy plugs to plug in
5 minute installation
The price Is Amazing .99
Bulk quantities available also!
You Tube tutorial also on youtube
www.Tunemytruck.com